Page 2 of 51. Showing 503 results (0.013 seconds)
Spanning Tree Protocol
designated-port-count: 1 fast-forward: yes Note that the root bridge doesn't have any root ports, only designated ports. You can check the STP status … the root bridge and will be used to forward traffic from/to the root bridge. alternate-port - port that is facing towards the root bridge, but is not goingBridge VLAN Table
to drop the packets when they are received (ingress). Management access - The bridge is supposed to simply forward packets between bridge ports and it would … this port to forward. It is possible that a port is a tagged port for one VLAN ID and the same port is an untagged port for a different VLAN IDSwitch Chip Features
for ingress traffic. No traffic is dropped when set on the ingress port. fallback - checks tagged traffic against the VLAN Table for ingress traffic and forwards … . If a VLAN ID is not found in the VLAN Table, then traffic is forwarded. Used to allow known VLANs only in specific ports. check - checks tagged traffic againstPacket Flow in RouterOS
place when a packet is forwarded from one bridge port to another, essentially connecting multiple devices on the same network. After receiving a packet … flooded (e.g. broadcast, multicast, unknown unicast traffic), gets multiplied per bridge port and then processed further in the bridge forward chain. When usingCSS106 (RB260) series Manual
- whether traffic entering this port must be copied and forwarded to the mirroring target port Mirror Egress - whether traffic leaving this port must be copied and forwarded to the mirroring target port Mirror To - mirroring target port Bandwidth Limit Egress Rate - limit traffic leaving this port (bpsBuilding Advanced Firewall
: accept IKE" protocol=udp dst-port=500,4500 add action=accept chain=forward comment="defconf: accept AH" protocol=ipsec-ah add action=accept chain=forward … traceroute" dst-port=33434-33534 protocol=udp add action=accept chain=input comment="defconf: accept DHCPv6-Client prefix delegation." dst-port=546 protocolCRS1xx/2xx series switches examples
and the CPU port (switch1-cpu) to forward the selected VLAN ID, therefore allowing management access: /interface ethernet switch vlan add ports=ether2,switch1-cpu vlan-id … is forwarded only between access ports, the /interface ethernet switch egress-vlan-tag entry should still be created without any tagged ports. Another optionGPEN21 series Manual
interfaces. Packets received on downstream ports are forwarded only to the uplink port, only a single interface can be used as an uplink. Broadcast Storm … on egress ports, then with VLAN Receive=any the device will remove the VLAN tag and forward the packet. optional - Disabled VLAN filtering. Handle packetsBridge IGMP/MLD snooping
(name; Default: ) The list of bridge ports to which the multicast group will be forwarded. vid (integer: 1..4094; Default: ) The VLAN ID on which the MDB … -port: none port-count: 3 designated-port-count: 3 fast-forward: no multicast-router: no igmp-querier: ether2Container
be able to access the PiHole web panel by navigating to http://172.17.0.2/admin/ in your web browser. Forward ports to internal container Ports can be forwarded … /ip/address/add address=172.17.0.1/24 interface=containers /interface/bridge/port add bridge=containers interface=veth1 Setup NAT for outgoing traffic: /ip