Page 3 of 51. Showing 503 results (0.012 seconds)
CRS3xx, CRS5xx, CCR2116, CCR2216 switch chip features
a packet is being forwarded to the CPU, the pvid property for the bridge port will be always used instead of new-vlan-id from ACL rules. MAC-based VLANs … device supports. Protocol-based VLANs will only work properly between switch ports and not between switch ports and CPU. When a packet is being forwardedSerial Console
to the router via the serial port using a /system serial-terminal command. All keyboard input will be forwarded to the serial port and all data from the port is output … Overview The Serial Console and Serial Terminal are tools, used to communicate with devices and other systems that are interconnected via the serial portContainer - HomeAssistant
interfaces to it: /interface/bridge/add name=ha /ip/address/add address=172.19.0.1/24 interface=ha /interface/bridge/port add bridge=ha interface=veth2 Forward TCP 8123 … =dstnat dst-address=192.168.88.1 dst-port=8123 protocol=tcp to-addresses=172.19.0.2 to-ports=8123 Environment variables and mounts Per the home-assistContainer - mosquitto MQTT server
veth to it: /interface/bridge/add name=msqt /ip/address/add address=172.19.0.1/24 interface=msqt /interface/bridge/port add bridge=msqt interface=veth2 Forward … -standard ports ...etc; Use SSL MQTT. Container configuration Sub-menu: /container note: container package is required. Container mode Enable container modeCAPsMAN with VLANs
and CAPsMAN Router. By default, if PVID is not changed, untagged traffic is going to be forwarded between ports that have the same PVID value set (including … throughput), while CAPsMAN Forwarding Mode should be used when all traffic should always be forwarded to the CAPsMAN router (in most cases to filter packetsWoobm-USB
. For Telnet access open Woobm-USB address in telnet client. Woobm-USB forwards serial port to telnet client. Only one instance of the serial port bridge may … image2020-2-7_10-12-57.png The Woobm is a WiFi-to-serial bridge. This device enables wireless access to RouterBOARD devices which have a USB port but doDST-NAT port forwarding
protokolu, piemēram TCP; Dst. Port, norādiet portu, kurš tiks pārsūtīts, piemēram ports 80; In. Interface List norādiet to ienākošo interfeisu uz kuruCRS1xx/2xx series switches
. port (port) Physical port or trunk for ingress port policer entry. rate (integer) Maximum data rate limit. yellow-action (drop | forward | remark; Default … -ports; Default: forward) copy-to-cpu - Packets are copied to the CPU if they match the ACL conditions. drop - Packets are dropped if they match the ACLPorts
Summary There are many ways how to use ports on the routers. Most obvious one is to use serial port for initial RouterOS configuration after installation (by default serial0 is used by serial-terminal). Serial and USB ports can also be used to: connect 3G modems; connect to another device through a serial cableLTE_CPE_AP_router.txt
chain=forward action=accept protocol=139 comment="defconf: accept HIP" filter add chain=forward action=accept protocol=udp dst-port=500,4500 … RouterMode: #| * wireless interface connected to providers network (WAN port); #| * WAN port is protected by firewall