/routing/rip/instance
| Property | Description |
|---|
| name | name of the instance |
| vrf ( Default: main) | which VRF to use |
| afi (ipv4 | ipv6; Default: ) | specifies which afi to use. |
| in-filter-chain (Default: ) | input filter chain |
| out-filter-chain (Default: ) | output filter chain |
| out-filter-select (Default: ) | output filter select rule chain |
| redistribute (bgp, bgp-mpls-vpn, connected, dhcp, fantasy, modem, ospf, rip, static, vpn; Default: ) | which routes to redistribute |
| originate-default ( Default:) | whether to originate default route |
| routing-table ( Default: main) | in which routing table the routes will be added |
| route-timeout (Default: ) | route timeout |
| route-gc-timeout (Default: ) |
|
| update-interval (time; Default: ) | specifies time interval after which the route is considered invalid |
Note: The maximum metric of RIP route is 15. Metric higher than 15 is considered 'infinity' and routes with such metric are considered unreachable. Thus RIP cannot be used on networks with more than 15 hops between any two routers, and using redistribute metrics larger that 1 further reduces this maximum hop count.
/routing/rip/interface-template
| Property | Description |
|---|
| name | name of the instance |
| instance | which VRF to use |
| interfaces | specifies which afi to use. |
| source-addresses | input filter chain |
| cost (Default: ) | output filter chain |
| split-horizon (no| yes ) |
|
| poison-reverse (no| yes ) |
|
| mode (passive| strict) |
|
| key-chain (name) | Name of key-chain which contains MD5 key. Should be set only when MD5 authentication is needed. |
| password | Password for plain text authentication. Should be set only when plain-text authentication is needed. |
/routing/rip/interface
| Read-only Property | Description |
|---|
| instance (name) | name of the instance |
| address (address%interface ) | IP address and interface name |
/routing/rip/neighbor
This submenu is used to define a neighboring routers to exchange routing information with. Normally there is no need to add the neighbors, if multicasting is working properly within the network. If there are problems with exchanging routing information, neighbor routers can be added to the list. It will force the router to exchange the routing information with the neighbor using regular unicast packets.
| Read-only Property | Description |
|---|
| address (IP address) | IP address of neighboring router |
| routes | amount of routes |
| packets-total | amount of all packets |
| packets-bad | amount of bad packets |
| entries-bad | amount of bad entries |
| last-update (time) | time from last update |
/routing/rip/static-neighbor
| Property | Description |
|---|
| instance (name) | name of used instance |
| address (IP address) | IP address of neighboring router |
/routing/rip/keys
MD5 authentication key chains.
| Property | Description |
|---|
| chain (string; Default: "") | chain name to place this key in. |
| key (string; Default: "") | authentication key. Maximal length 16 characters |
| key-id (integer:0..255; Default: ) | key identifier. This number is included in MD5 authenticated RIP messages, and determines witch key to use to check authentication for a specific message. |
| valid-from (date and time; Default: today's date and time: 00:00:00) | key is valid from this date and time |
| valid-till (date and time; Default: today's date and time: 00:00:00) | key is valid until this date and time |