...

Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing accidents.
Ultimate disposal of this product should be handled according to all national laws and regulations.
All installation methods for mounting an access point on any wall surface is subject to the acceptance of local jurisdiction.
The Installation of the equipment must comply with local and national electrical codes.
This product is intended to be mounted outdoors on a pole. Please read the mounting instructions carefully before beginning installation. Failure to use the correct hardware and configuration or to follow the correct procedures could result in a hazardous situation for people and damage to the system.
Use only the power supply and accessories approved by the manufacturer, and which can be found in the original packaging of this product.
Read the installation instructions before connecting the system to the power source.
We cannot guarantee that no accidents or damage will occur due to the improper use of the device. Please use this product with care and operate at your own risk!
In the case of device failure, please disconnect it from power. The fastest way to do so is by unplugging the power plug from the power outlet.
It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels, output power, cabling requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik radio devices must be professionally installed.This is a class A device. In a domestic environment, this product might cause radio interference in which case the user might be required to take adequate measures.

Quickstart

Please follow these quick steps to set up your device:

• Mount unit in your desired place, please see Mounting paragraph.
• Slide off latch to access Ethernet port. Please see Opening latch section.
• Connect your PoE cable to the Ethernet port, please see Powering section.
• Set your computer IP configuration to automatic (DHCP).
• From your PC connect to the wireless network name which starts with "MikroTik".
• Once connected to the wireless network, open https://192.168.88.1 in your web browser to start the configuration.
• User name: admin and there is no password by default you will be logged in automatically to the Quick Set screen (or, for some models, check user and wireless passwords on the sticker).
• We recommend clicking the "Check for updates" button on the right side and updating your RouterOS software to the latest version to ensure the best performance and stability.
• To personalize your wireless network, SSID can be changed in the fields "Network Name".
• Choose your country on the left side of the screen in the field "Country", to apply country regulation settings.
• Set up your wireless network password in the field "WiFi Password" the password must be at least eight symbols.
• Set up your router password in the bottom field "Password" to the right and repeat it in the field "Confirm Password", it will be used to login next time.
• Click on the "Apply Configuration" to save changes.

...

UKCA marking

Eurasian Conformity Mark

*Доступные частотные каналы могут различаться в зависимости от модели продукта и сертификации. 

...