...
| Property | Description |
|---|---|
| arp (disabled | enabled | proxy-arp | reply-only; Default: enabled) | Read more >> |
| arp-timeout (auto | integer; Default: auto) | ARP timeout is time how long ARP record is kept in ARP table after no packets are received from IP. Value auto equals to the value of arp-timeout in /ip settings, default is 30s |
| comment (string; Default: ) | Short description of the interface |
| disabled (yes | no; Default: yes) | Whether interface is disabled |
| frequency (58320 | 60480 | 62640 | 64800 | 66000 | auto; Default: auto) | Frequency used in communication (Only active on bridge device) |
| isolate-stations (yes | no; Default: yes) | Don't allow communication between connected clients (from RouterOS 6.41) |
| l2mtu (integer [0..7882]; Default: 1600) | Layer2 Maximum transmission unit |
| mac-address (MAC; Default: ) | MAC address of the radio interface |
| mdmg-fix (yes | no; Default: no) | Experimental feature working only on wAP60Gx3 devices, providing better point to multi point stability in some cases |
| mode (ap-bridge | bridge | sniff | station-bridge; Default: bridge) | Operation mode |
| mtu (integer [32..8192]; Default: 1500) | Layer3 Maximum transmission unit |
| name (string; Default: wlan60-1) | Name of the interface |
| password (string; Default: randomly generated) | Password used for AES encryption |
| put-stations-in-bridge (; Default: ) | Put newly created station device interfaces in this bridge |
| region (asia | australia | canada | china | eu | japan | no-region-set | usa; Default: no-region-set) | Parameter to limit frequency use |
| scan-list (58320,60480,62640,64800,66000; Default: 58320,60480,62640,64800) | Scan list to limit connectivity over frequencies in station mode |
| ssid (string (0..32 chars); Default: value of System Identity) | SSID (service set identifier) is a name that identifies wireless network |
| tx-sector (integer [0..63] | auto; Default: auto) | Disables beamforming and locks to selected radiation pattern |
...
Warning: ap-bridge device requires License level 4 (click for more information) to support more than one connected client
...
Now this interface can be used in Tools/Packet Sniffer for packet capture. Sniffer mode can't be used together with regular interface working modes.
...
Warning: Before configuration, make sure devices are running latest software versions: How to upgrade
Minimal configuration for transparent wireless link is matching SSID, correct mode (bridge || station-bridge) and Wireless and Ethernet interfaces put in same bridge.
...
wAP60G AP units come pre-configured with WISP Bridge default configuration
SSID and bridge between Wireless and Ethernet interfaces is already configured. It's recommended to set up Wireless password and change SSID. If device has been reset, you can also set correct mode and enable interface.
...
InterfaceID is added from 3 and increases by +1 for each connected station. More information about SNMP functionality and MIB files can be found in SNMP wikimanual
Configuration Reset For Wireless Wire kits
Reset button has same functionality as on other devices, explained in detail here
5 second button hold on startup (USR LED light starts flashing) - resets to password protected state.
...
Warning: After complete removal of configuration, only mac-telnet connection may be established
...