R11e-LTE-US
R11e-LTE-US is a Cat-4 modem. It can be integrated into any MikroTik product that has a miniPCI-e slot.
Specifications
...
- Use a wrist grounding strap when unpacking and working with electrical components to avoid electrical discharge (ESD) damage;
- After unpacking please place the card on the anti-static mat;
- When installing make sure there are no objects that can damage or touch the PCB plate;
- The card can be installed in your desired device using the factory provided screw holes in a PCB plate;
...
- Locate miniPCIe slot on your device;
- Unscrew two factory attached screws;
- Optionally you can use the thermal pad by placing it under the card, the thermal pad is not included in the package;
- Install the module to the miniPCIe slot and secure it with previously removed screws. Tightening torque 0,3 Nm;
- Attach antenna cables to the connectors on the module:
| Info |
|---|
When installing outdoors please ensure that the device case is waterproof and is designed for outdoor use. The IP rating scale for this device is IP0. |
...
The device will be automatically recognized when used in a MikroTik RouterOS powered device. Configuration can be set in the “Wireless” menu. More information about using RouterOS the configuration of LTE can be found in our documentation: https://mt.lv/helpwiki.mikrotik.com/wiki/Manual:Interface/LTE
The device is tested with RouterOS v6 and above. It might be compatible with other operating systems, but drivers are not included with the card.
...
The module supports RouterOS software version v6.46. Other operating systems have not been tested.
...
It is the installer's responsibility to ensure that when using the authorized antennas in the United States (or where FCC rules apply); only those antennas certified with the product are used. The use of any antenna other than those certified with the product is expressly forbidden in accordance to with FCC rules CFR47 part 15.204. The installer should configure the output power level of antennas, according to country regulations and per antenna type.
...
This device complies with Industry Canada licence's license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, mźme si le brouillage est susceptible d'en compromettre le fonctionnement.
...