R11e-LTE-US
R11e-LTE-US is Cat-4 modem. It can be integrated into any MikroTik product that has miniPCI-e slot.
Specifications
- Interface – Mini-PCIe;
- Temperature Operating -30°C .. +70°C
- LTE Channel Bandwidth: 1.4/3/5/10/15/20 MHz
- LTE Category: 4 (150Mbps Downlink, 50Mbps Uplink)
- 3G Category: R8 (Cat24 - 42.2Mbps Downlink) / R7 (Cat14 - 21.1Mbps Downlink)
- 2G Category: Class12
- LTE (FDD) bands: 2/4/5/12 (1900/1700/850/700)
- 3G bands: 2/5 (1900/850)
Installing the module in your device
R11e-TE-US for professional use. Each of the cards comes in ESD protective packaging. When handling electrical equipment please observe the following safety precautions:
...
| Info |
|---|
When installing outdoors please ensure that the device case is waterproof and is designed for outdoor use. The IP rating scale for this device is IP0. |
Configuration
The device will be automatically recognized when used in a MikroTik RouterOS powered device. Configuration can be set in the “Wireless” menu. More information about using RouterOS can be found in our documentation: https://mt.lv/help
The device is tested with RouterOS v6 and above. It might be compatible with other operating systems, but drivers are not included with the card.
Operating system support
The module supports RouterOS software version v6. Other operating systems have not been tested.
Federal Communication Commission Interference Statement
FCC ID: TV7R11ELTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
...
It is the installer's responsibility to ensure that when using the authorized antennas in the United States (or where FCC rules apply); only those antennas certified with the product are used. The use of any antenna other than those certified with the product is expressly forbidden in accordance to FCC rules CFR47 part 15.204. The installer should configure the output power level of antennas, according to country regulations and per antenna type.
Industry Canada
IC: 7442A-R11ELTE
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, mźme si le brouillage est susceptible d'en compromettre le fonctionnement.
CAN ICES-3(B)/ NMB-3(B)
Important Notice to OEM integrators
1. This module is limited to OEM installation ONLY.
...