...

Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing accidents.
Ultimate disposal of this product should be handled according to all national laws and regulations.
The Installation of the equipment must comply with local and national electrical codes.
This product is intended to be installed indoors. Keep this product away from water, fire, humidity or hot environments.
Use only the power supply and accessories approved by the manufacturer, and which can be found in the original packaging of this product.
Read the installation instructions before connecting the system to the power source.
We cannot guarantee that no accidents or damage will occur due to the improper use of the device. Please use this product with care and operate at your own risk!
In the case of device failure, please disconnect it from power. The fastest way to do so is by unplugging the power plug from the power outlet.
It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels, output power, cabling requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik radio devices must be professionally installed.

...

First, the RouterBOOT loader is started. It displays boot information on the onboard RS232C asynchronous serial port. The serial port is set by default to 115200bit/s, 8 data bits, 1 stop bit, no parity.
The RouterOS system will then load. It will be also indicated by two beeps.
You can connect to the device with SSH, Winbox GUI or the web interface, by plugging your computer into port Ether1, and connecting to 192.168.88.1 user admin and no password (or, for some models, check user and wireless passwords on the sticker). The device doesn't have a DHCP server enabled by default, your PC should be configured with an address from this network.
More information on connecting to the device:+ https://mt.lv/help+^{Image Removed}

Extension slots and ports

• 13x Gigabit Ethernet ports, supporting automatic cross/straight cable correction (Auto MDI/X), so you can use either straight or cross-over cables for connecting to other network devices. ETH13 port accepts PoE power, and can be used to boot the device from the network for reinstalling with the Netinstall utility (see documentation)
• DB9 RS232C asynchronous serial port
• microSD slot
• 2x M.2 slots, accepting SATA type M.2 SSD disks in 2280 form factor (only Dx4 model)
• 2x 2.5 inch SATA connectors, accepting standard 2.5" SATA HDD disks (only Dx4 model)

Buttons and jumpers

The reset button has the following functions:

...