...
- Connect your Internet cable to the first port, and local network PCs to the other ports.
- Choose your powering solution, please see the Powering section for possibilities.
- Set your computer IP configuration to automatic (DHCP).
- The default IP address from the local network is 192.168.88.1, open this address in your web browser to start the configuration. The username is admin and there is no password (or, for some models, check user and wireless passwords on the sticker).
- We recommend clicking the "Check for updates" button and updating your RouterOS software to the latest version to ensure the best performance and stability. The device needs to have an active Internet connection.
- Set up a strong password for the device.
...
- Direct-input power jack (5.5 mm outside and 2.1 mm inside, female, pin positive plug) accepts 12-57 V DC.
- The First Ethernet port accepts Power over Ethernet 18-57 V DC.
...
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed before power is applied to the device. Useful for RouterBOOT debugging and recovery.
Operating system support
The device supports RouterOS software version 6 . The specific factory-installed version number is and RouterOS version 7 or above, as indicated in the RouterOS menu under /system resource. Other operating systems have not been tested.
Accessories
Package includes the following accessories that come with the device:
...
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class
...
A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
...
a commercial installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
...
instruction manual, may cause harmful interference to radio communications.
...
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the
...
user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This unit was tested with shielded cables on the peripheral devices. Shielded cables must be used with the unit to ensure compliance.
Innovation, Science and Economic Development Canada
This device
...
contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS
...
(s). Operation is subject to the following two conditions: (1)
...
This device may not cause interference
...
. (2)
...
This device must accept any interference, including interference that may cause undesired operation of the device.
...
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
...
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.
...
L’exploitation est autorisée aux deux conditions suivantes :
...
1)
...
L’appareil ne doit pas produire de brouillage
...
; 2)
...
L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
...
d’en compromettre le fonctionnement.
This Class B digital Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [BA] est conforme à la norme NMB-003 du Canada.
CAN ICES-003 (BA) / NMB-003 (BA)
UKCA marking
Eurasian Conformity Mark
...