...
- Connect the antenna to the N-Male connector.
- Twist to open the Groove case, and connect an Ethernet cable to the Ethernet port.
- The Groove accepts 8-30 V Passive PoE from a PoE injector. The included injector should be
connected with the “Data” end into a switch or other router, the “Data + Power” port should be
connected to the Groove, by using an Ethernet cable of the desired length (not included). - Use the provided rubber insulator to put on the Ethernet cable, and push it into the case opening,
so that the opening is tightly closed. - To configure the device, for the access point models (A) you should connect to the wireless network that begins with “MikroTik”. For the CPE models, the configuration is done from the Ethernet port.
- Log in to the device from your web browser by opening 192.168.88.1 in the address bar, user name admin and no passwordDefault IP is not set, the user name:is admin and there is no password, or use the Neighbors tab and connect through the MAC address (or, for some models, check user and wireless passwords on the sticker). Set the WiFi network password, the device password, any other settings and choose the country where the device is used, to comply with local regulations.
Powering
The device accepts powering from an Ethernet port (Passive PoE). Under maximum load, the power consumption of this device is 4 W.
...