...
- Yellow - partially working
- Green - Working
- Red - Not working at the moment
Feature | v7.0Beta7 | v7.1Beta1 | v7.1Beta2 | v7.1Beta3 | v7.1Beta4 | v7.1rc1 | v7.1rc2 | v7.1rc3 | v7.1rc5 |
---|---|---|---|---|---|---|---|---|---|
Winbox | |||||||||
BGP support | |||||||||
OSPF support | |||||||||
RIP support | |||||||||
Router ID support | |||||||||
Routing filter support | Sets rule as string | ||||||||
Generic | |||||||||
/31 address support | N/A | ||||||||
Convert route rules after upgrade from v6.x | N/A | OK | |||||||
Static IPv6 upgrade from ROS v6 | NOK | OK | |||||||
IPv4 Route Rules | OK | ||||||||
IPv6 Route Rules | NOK | OK | |||||||
ECMP flags | OK | ||||||||
dst@table | OK | ||||||||
gateway@table | OK | ||||||||
gateway%interface | OK | ||||||||
recursive route over ipv6 LL address | OK | ||||||||
3 level recursive gateway with ECMP | OK | ||||||||
IPV6 ECMP | OK | ||||||||
IPv6 connected ECMP | N/A | OK | |||||||
Addresses from same subnet to multiple interfaces | NOK | ||||||||
Show time when route was last updated | N/A | ||||||||
Check Gateway | Ping OK, ARP NOK (works as ping), BFD NOK (not implemented) | ||||||||
Scope and target scope | OK | ||||||||
IPv4 Mangle routing-mark | OK | ||||||||
IPv6 Mangle routing-mark | NOK (Added but does not work at the moment) | OK | |||||||
Packet SRC address | NOK (wrong src is picked for locally originated packets) | Does not work correctly with /32 addresses | |||||||
Routing-table parameter for ping and telnet | NOK | ||||||||
Show if route is hardware accelerated | N/A | Shows if route is candidate for HW acceleration | |||||||
Custom route selection policy | N/A | ||||||||
IPv4 with IPv6 nexthops and RFC5549 | N/A | OK | |||||||
Routing Instance | OK | Renamed to Router-ID | |||||||
VRF | Needs more testing | ||||||||
Some kind of mechanism to import/export routes from one vrf to another within same router | N/A | ||||||||
BFD | N/A | ||||||||
OSPF | |||||||||
Convert OSPF config from v6 to v7 after upgrade | N/A | Known conversion problems:
| |||||||
OSPF neighbors in NSSA Area | Cannot establish adjacency | ||||||||
OSPF in broadcast network | Does not work with more than 2 neighbors | OK | |||||||
OSPF with routing filters | OK | ||||||||
OSPF Virtual Link | OK | ||||||||
OPSF input filtering | N/A | ||||||||
HMAC-SHA auth RFC5709 | N/A | ||||||||
BGP and OSPF SNMP monitoring | N/A | ||||||||
BGP | |||||||||
Convert BGP config from v6 to v7 after upgrade | N/A | OK | |||||||
BGP Templates and dynamic peers | OK | ||||||||
BGP connect listen on a network | OK | ||||||||
BGP guess remote.as | OK | ||||||||
Show from which peer route received | OK ( /routing/route/print detail --> belongs-to) | ||||||||
BGP Address Families | Currently only IPv4, IPv6 | ||||||||
BGP input.accept-* | Does not work right after peer established, need to resend routes | ||||||||
eBGP nexthop self | OK | ||||||||
Input Filter | OK | ||||||||
Output Filter | OK | ||||||||
BGP Local address auto selection | OK | ||||||||
BGP route reflect | OK | ||||||||
BGP route server | OK | ||||||||
BGP Roles https://datatracker.ietf.org/doc/draft-ietf-idr-bgp-open-policy/?include_text=1 | OK | ||||||||
BGP peer-cache uptime in "established" state | N/A | ||||||||
BGP Flow Spec | Flow spec attributes are forwarded | ||||||||
BGP Selection | OK | ||||||||
BGP Selection (Multipath) | N/A | ||||||||
BGP Confederation | OK | ||||||||
BGP Aggregation | N/A | ||||||||
BGP ORF | N/A | ||||||||
Discard prefix RTBH RFC 6666 | N/A | ||||||||
AS-wide Unique BGP Identifier RFC 6286 | N/A | ||||||||
Exported PDU PCAP saver | Ok | ||||||||
Exported PDU PCAP loader | |||||||||
MPLS | |||||||||
Static label mapping | N/A | ||||||||
Static mapping upgrade from v6 | |||||||||
LDP IPv4 mapping | N/A | Ok | |||||||
LDP IPv6 mapping | N/A | ||||||||
LDP signaled VPLS | N/A | Ok | |||||||
LDP config upgrade from v6 | N/A | ||||||||
TE | N/A | ||||||||
TE Config upgrade from v6 | N/A | ||||||||
VPLS Encap to TE | N/A | ||||||||
BGP signaled VPLS | N/A | ||||||||
VPLS config upgrade from v6 | N/A | ||||||||
Fast reroute | N/A | ||||||||
MPLS ECMP | N/A | ||||||||
One label per VRF | N/A | ||||||||
Ability to use MPLS EXP-bit in Queues | N/A | ||||||||
MPLS Fast-Path | N/A | ||||||||
RPKI session | OK | ||||||||
RPKI possibility to view received info of specific prefix | N/A | OK | |||||||
RPKI show connection status | N/A | Ok | |||||||
Filters | |||||||||
Convert routing filters after upgrade from v6.x | N/A | ||||||||
Syntax completion | N/A | Completion works but needs fine-tuning | |||||||
Routing filter chain drop by default without rules | OK | ||||||||
Routing filter prefix match | OK | ||||||||
Routing filter protocol match | Missing other protocols like modem DHCP etc (these routes are not matched by "static") | ||||||||
Routing filter append communities | OK | ||||||||
Routing filter append large community | OK | ||||||||
Routing filter set weight | "sub, add" does not work if attribute has default unset value, if attribute is not set then default value should be assumed. | ||||||||
Routing filter set local pref | "sub, add" does not work if attribute has default unset value, default value should be 100 if not set. | ||||||||
Routing filter set MED | "sub,add" should assume default value. | ||||||||
Routing filter set origin | OK | ||||||||
Routing filter set igp metric from OSPF cost | Can be set with set-num-prop=bgp-igp-metric<add>ospf-ext-metric or ospf-metric, but what to do if it is not possible to guess which metric to use? | ||||||||
Routing filter match prefix with address list | OK | ||||||||
Routing filter match community/large community lists | OK | ||||||||
Routing filter add prefix to address list | N/A | ||||||||
Routing filter validate prefix with RPKI | OK | ||||||||
Multicast | |||||||||
IGMP-Proxy | N/A | ||||||||
PIM-SM |
Performance Status
Used hardware:
...