...
- Yellow - partially working
- Green - Working
- Red - Not working at the moment
Feature | v7.0Beta7 | v7.1Beta1 | v7.1Beta2 | v7.1Beta3 | v7.1Beta4 | v7.1rc1 | v7.1rc2 | v7.1rc3 |
|---|---|---|---|---|---|---|---|---|
| Winbox | ||||||||
| BGP support | ||||||||
| OSPF support | ||||||||
| RIP support | ||||||||
| Router ID support | ||||||||
| Routing filter support | Sets rule as string | |||||||
| Generic | ||||||||
| /31 address support | N/A | |||||||
| Convert route rules after upgrade from v6.x | N/A | OK | ||||||
| Static IPv6 upgrade from ROS v6 | NOK | OK | ||||||
| IPv4 Route Rules | OK | |||||||
| IPv6 Route Rules | NOK | OK | ||||||
| ECMP flags | OK | |||||||
| dst@table | OK | |||||||
| gateway@table | OK | |||||||
| gateway%interface | OK | |||||||
| recursive route over ipv6 LL address | OK | |||||||
| 3 level recursive gateway with ECMP | OK | |||||||
| IPV6 ECMP | OK | |||||||
| IPv6 connected ECMP | N/A | OK | ||||||
| Addresses from same subnet to multiple interfaces | NOK | |||||||
| Show time when route was last updated | N/A | |||||||
| Check Gateway | Ping OK, ARP NOK (works as ping), BFD NOK (not implemented) | |||||||
| Scope and target scope | OK | |||||||
| IPv4 Mangle routing-mark | OK | |||||||
| IPv6 Mangle routing-mark | NOK (Added but does not work at the moment) | OK | ||||||
| Packet SRC address | NOK (wrong src is picked for locally originated packets) | Does not work correctly with /32 addresses | ||||||
| Routing-table parameter for ping and telnet | NOK | |||||||
| Show if route is hardware accelerated | N/A | Shows if route is candidate for HW acceleration | ||||||
| Custom route selection policy | N/A | |||||||
| IPv4 with IPv6 nexthops and RFC5549 | N/A | OK | ||||||
| Routing Instance | OK | Renamed to Router-ID | ||||||
| VRF | Needs more testing | |||||||
| Some kind of mechanism to import/export routes from one vrf to another within same router | N/A | |||||||
| BFD | N/A | |||||||
| OSPF | ||||||||
| Convert OSPF config from v6 to v7 after upgrade | N/A | |||||||
Known conversion problems:
| ||||||||
| OSPF neighbors in NSSA Area | Cannot establish adjacency | |||||||
| OSPF in broadcast network | Does not work with more than 2 |
| neighbors | OK | |||||||
| OSPF with routing filters | OK | |||||||
| OSPF Virtual Link | OK | |||||||
| OPSF input filtering | N/A | |||||||
| HMAC-SHA auth RFC5709 | N/A | |||||||
| BGP and OSPF SNMP monitoring | N/A | |||||||
| BGP | ||||||||
| Convert BGP config from v6 to v7 after upgrade | N/A | OK | ||||||
| BGP Templates and dynamic peers | OK | |||||||
| BGP connect listen on a network | OK | |||||||
| BGP guess remote.as | OK | |||||||
| Show from which peer route received | OK ( /routing/route/print detail --> belongs-to) | |||||||
| BGP Address Families | Currently only IPv4, IPv6 | |||||||
| BGP input.accept-* | Does not work right after peer established, need to resend routes | |||||||
| eBGP nexthop self | OK | |||||||
| Input Filter | OK | |||||||
| Output Filter | OK | |||||||
| BGP Local address auto selection | OK | |||||||
| BGP route reflect | OK | |||||||
| BGP route server | OK | |||||||
| BGP Roles https://datatracker.ietf.org/doc/draft-ietf-idr-bgp-open-policy/?include_text=1 | OK | |||||||
| BGP peer-cache uptime in "established" state | N/A | |||||||
| BGP Flow Spec | Flow spec attributes are forwarded | |||||||
| BGP Selection | OK | |||||||
| BGP Selection (Multipath) | N/A | |||||||
| BGP Confederation | OK | |||||||
| BGP Aggregation | N/A | |||||||
| BGP ORF | N/A | |||||||
| Discard prefix RTBH RFC 6666 | N/A | |||||||
| AS-wide Unique BGP Identifier RFC 6286 | N/A | |||||||
| Exported PDU PCAP saver | Ok | |||||||
| Exported PDU PCAP loader | ||||||||
| MPLS | ||||||||
| Static label mapping | N/A | |||||||
| Static mapping upgrade from v6 | ||||||||
| LDP IPv4 mapping | N/A | Ok | ||||||
| LDP IPv6 mapping | N/A | |||||||
| LDP signaled VPLS | N/A | Ok | ||||||
| LDP config upgrade from v6 | N/A | |||||||
| TE | N/A | |||||||
| TE Config upgrade from v6 | N/A | |||||||
| VPLS Encap to TE | N/A | |||||||
| BGP signaled VPLS | N/A | |||||||
| VPLS config upgrade from v6 | N/A | |||||||
| Fast reroute | N/A | |||||||
| MPLS ECMP | N/A | |||||||
| One label per VRF | N/A | |||||||
| Ability to use MPLS EXP-bit in Queues | N/A | |||||||
| MPLS Fast-Path | N/A | |||||||
| RPKI session | OK | |||||||
| RPKI possibility to view received info of specific prefix | N/A | OK | ||||||
| RPKI show connection status | N/A | Ok | ||||||
| Filters | ||||||||
| Convert routing filters after upgrade from v6.x | N/A | |||||||
| Syntax completion | N/A | Completion works but needs fine-tuning | ||||||
| Routing filter chain drop by default without rules | OK | |||||||
| Routing filter prefix match | OK | |||||||
| Routing filter protocol match | Missing other protocols like modem DHCP etc (these routes are not matched by "static") | |||||||
| Routing filter append communities | OK | |||||||
| Routing filter append large community | OK | |||||||
| Routing filter set weight | "sub, add" does not work if attribute has default unset value, if attribute is not set then default value should be assumed. | |||||||
| Routing filter set local pref | "sub, add" does not work if attribute has default unset value, default value should be 100 if not set. | |||||||
| Routing filter set MED | "sub,add" should assume default value. | |||||||
| Routing filter set origin | OK | |||||||
| Routing filter set igp metric from OSPF cost | Can be set with set-num-prop=bgp-igp-metric<add>ospf-ext-metric or ospf-metric, but what to do if it is not possible to guess which metric to use? | |||||||
| Routing filter match prefix with address list | OK | |||||||
| Routing filter match community/large community lists | OK | |||||||
| Routing filter add prefix to address list | N/A | |||||||
| Routing filter validate prefix with RPKI | OK | |||||||
| Multicast | ||||||||
| IGMP-Proxy | N/A | |||||||
| PIM-SM | ||||||||
Performance Status
Used hardware:
...