...
When the product arrives from manufacturing it is set into factory sleep mode. In this mode, all components are shut-down as much as possible and MCU is put into the deepest sleep state. The current draw is reduced to a minimum, so this is the preferred mode to use when the tag is stored and/or not in use. To exit this mode put a magnet to the tag's edge (where the switch icon Bluetooth logo is) and hold it for 3-10 seconds until LED turns off. After that, the tags exits sleep mode and enters advertising mode.
...
Configuration mode can be entered only from advertising mode by applying a magnet to the same switch icon Bluetooth logo as in the exiting factory sleep procedure. After applying a magnet for 5-10 seconds LED will turn off and the tag enters configuration mode. If you apply a magnet for longer than 15 seconds or won't connect to the tag with the configuration app, it will go back into advertising mode.
When the device wakes from the factory sleep for the first time, it has this default configuration:
| Configuration parameter | Setting/value |
|---|---|
| Advertising packet format | MikroTik |
| Advertising interval | 5.0 seconds |
| Tilt trigger | 60° |
| Accelerometer trigger | 156.25 mg |
| Low noise filter | enabled |
| Tx Power | 6 dBm |
The magnet is used on the reed switch to change the tag's operating modes as described above. As soon as the magnet is detected (the reed switch is activated), the LED will start flashing for the next 5 seconds (first 5 seconds) and, then, stop. It can help you identify that 5 seconds have passed and that you can remove the magnet to enter configuration mode.
...