...
Upon the first login, you will see the list of "beaconed" devices.
General app settings
There are 3 options available on this screen:
To run "QR Code" reader | To change the order for recognized tags | To |
automatically scan for the nearby tags and/or check app version
enter "APP" settings or to "batch" configure multiple tags | ||
In the "APP" settings you have an option to configure an interval with which the phone scans for the nearby tags (that show up in the list of "beaconed" devices):
You can enable the "Save triggers" option (which will save detected triggers in the database) that will show triggers under "Sensor Triggers" (otherwise, if not enabled, "Sensor Triggers" data will be erased as soon as the app is closed):
And, lastly, in the settings menu, you can check the current app version.
"Batch Configuration" allows you to import (previously exported) tag configuration and apply it to multiple not-yet configured tags at once.
Preparation for the tag configuration
To "wake up" the tag, the reed switch should be activated for about 3-10 seconds (activating the reed switch = putting a magnet over the Bluetooth logo).
...
Right after that, you will need to put a magnet over a Bluetooth logo for about 10 -15 seconds to complete the steps:
note: When you put a magnet over the Bluetooth logo, the LED should turn on and it will stay on for the next 10 seconds. After 10 seconds the LED will turn off - that's when you can put away the magnet.
After a short wind up time, the device should be ready for the configuration:
...
The app will show general information about the tag in the "Status" tab (as shown in the screenshot above).
...
Tag configuration
Configuration can be altered in the "Settings" tab (settings shown in the screenshots below are "factory-default" settings):
...
Each type has an option to configure 3 4 parameters:
Property | Description |
---|---|
Advertisement interval (20ms...10s) | the interval in milliseconds after which an advertisement will be sent |
Freefall detect (on/off) | whether to send an advertisement when the accelerometer detects a freefall trigger |
Tilt detect (on/off) | whether to send an advertisement when the accelerometer detects a |
tilt trigger | |
Impact detect (on/off) | whether to send an advertisement when the accelerometer detects an impact/wake up |
Accelerometer settings:
In this menu, you can set up thresholds for the triggers.
Property | Description |
---|---|
Tilt trigger (50°...80°) | the threshold for a tilt/4D/6D function |
Accelerometer trigger |
|
Low noise filter (on/off) | whether to enable low noise filter - to reduce noise density in measurements |
Tx Power (-28dBm...6dBm) | the transmit power level in decibel-milliwatts |
System
In the "System" tab you can view the logs (access to saved info, error and other log messages), put the tag into factory sleep (if the mode is enabled, MCU will wait for the client to disconnect and then enter Factory sleep mode) and upgrade the firmware.
Property | Description |
---|---|
Logs | View system logs |
Factory sleep | Enters factory sleep mode |
Upgrade Firmware | Allows to upgrade Bluetooth tag firmware version |
Import/Export
Lastly, you can also import/export the tag configuration using the buttons shown in the screenshot above.