...

The mAP 2nD is a small wireless AP device with 2 Ethernet ports, Ether1 supports powering by PoE, Ether2 supports PoE output for powering another device. Depending on software configuration, it can function as a wireless client, an access point or a repeater.

Quick Start

RouterMode:
*WAN port is protected by firewall and enabled DHCP
*Wireless and Ethernet interface (except WAN port/s) are part of LAN bridge
LAN Configuration:
IP Address 192.168.88.1/24 is set on bridge (LAN port)
DHCP Server: enabled;
DNS: enabled;
wlan1 Configuration:
mode: ap-bridge;
band1band: 2ghz-b/g/n;
httx-chains: one: 0;1;
rx-chain: 0;1;
installation: indoor;
ht-extension: 20/40mhz-Ce;XX
WAN (gateway) configurationConfiguration:
gateway: ether1 (renamed with extension "-gateway");
firewallip4firwall: enabled;
NAT: enabled;
DHCP Client: enabled;LAN configuration:
LAN Port: bridge-local;
LAN IP: 192.168.88.1;
DHCP Server: enabled;

1. Connect your Internet cable to Ether1, and your PC to Ether2. If using the mAP to power another router using the PoE output feature, connect the router to Ether2, and use the built-in wireless AP to configure the mAP.
2. Set computer/router IP configuration to automatic (DHCP).
3. Wireless AP mode is enabled by default, you can connect to the SSID "MikroTik". Log into your router from your web browser by opening 192.168.88.1 in the address bar.
4. We recommend clicking the "Check for updates" button and updating your RouterOS software to the latest version to ensure the best performance and stability.
5. Choose your country, to apply country regulation settings and set up your password on the screen that loads.
6. The Ether2 port supports PoE output, with the auto-detection feature. This means you can connect Laptops and other non-PoE devices without damaging them. The PoE on Ether2 outputs approximately 2V below input voltage and supports up to 0.5 A (So provided 24V PSU will provide 22 V / 0.5 A output to the Ether2 PoE port).

...