This example shows how to configure transparent wireless bridge in GUI from one W60G device to another.
Example is done from empty configuration state with [WinBox] utility
After configuration reset - only mac-telnet is possible. In main WinBox screen press on Neighbours, choose your devices MAC address and press Connect:
Add new bridge and assign bridge members to it. This will allow to pass traffic from from Ethernet to W60G interface without routing.
Add interface members (ether1 and wlan60-1) to newly created bridge.
All previously explained steps are identical to bridge and station devices. Different modes needs to be used when configuring wireless interfaces.
Configure bridge device as follows:
Configure station device as follows:
Interfaces when enabled from greyed out will become active.
Link should be established after all previously explained steps are done. It's recommended to set up administrator password on both devices.
To create point to multi-point setup: On bridge device ap-bridge must be set and station-bridge for stations.