...

• Before you work on any MikroTik equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents. The installer should be familiar with network structures, terms, and concepts.
• Use only the power supplyand accessories approved by the manufacturer, and which can befoundin the original packaging of this product.
• This equipment is to be installed by trained and qualified personnel, as per these installation instructions. The installer is responsible for making sure, that Installation of the equipment is compliant with local and national electrical codes. Do not attempt to disassemble, repair, or modify the device.
• This product is intended to be mounted outdoors on a pole. Please read the mounting instructions carefully before beginning installation. Failure to use the correct hardware and configuration or to follow the correct procedures could result in a hazardous situation to people and damage to the system.
• We cannot guarantee that no accidents or damage will occur due to improper use of the device. Please use this product with care and operate at your own risk!
• This is a Class A product. In a domestic environment, this product might cause radio interference in which case the user might be required to take adequate measures.

Image Added

The product is certified in accordance with the rules of the UkrSEPRO system for compliance with the requirements of regulatory documents and the requirements stipulated by the current legislative acts of Ukraine.

Mexico Information:

Frequency range: 5725-5850 MHz. Available frequency channels may vary by model and product certification.

...

Antenna Installation WARNING: It is installer's responsibility to ensure that when using the authorized antennas in the Canada (or where IC rules apply); only those antennas certified with the product are to be used. The installer should configure the output power level of antennas, according to country regulations and per antenna type. Professional installation is required of equipment with connectors to ensure compliance with health and safety issues.

IMPORTANT: Exposure to Radio Frequency Radiation.

This equipment complies with the IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 375 cm between the radiator and any part of your body.

List of approved 5GHz antennas:

...

The same type of antenna and lower antenna gain than those listed above may also be used accordance to certification.

CE Declaration of Conformity

Manufacturer: Mikrotikls SIA, Brivibas gatve 214i Riga, Latvia, LV1039.

...

This equipment complies with EU radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 375 cm between the radiator and your body, unless specifically stated otherwise in page 1 of this document. In RouterOS you must specify your country, to make sure local wireless regulations are observed.

Operating Frequency

...

Frequency range (for applicable models)	Channels used	Maximum Output Power (EIRP)
5470-5725 MHz	100 - 140	27 dBm

...